National Time Large Outdoor Type Clock Movements and Hands 3MR Series

$1,345.00

These clock movements are built to your requirements and come complete with the mechanism, a pair of standard hands and the manual reset control switch. All mechanisms use a worm & worm gear drive. To order a clock mechanism, the proper hand size should be determined by measuring from the top of the 12 to the bottom of the 6 on your clock face design. The minute hand length is the dimension from the dial center to the tip of the hand. The hour hand will be proportionate. Shaft extensions are not adjustable in the field. Consult for larger requirements or details not shown. We can provide these movements with longer hand shafts (for up to 10" thick material) priced at about $20.00 per inch.

The 3MR series is a direct drive clock mechanism utilizing a single reversible motor. Hands cannot be manually turned. A standard unit can mount to a dial up to 3/4" thick. 

View Spec Sheet on this Item

Information on optional MC3 auto control unit

WIRING DETAILS: 

Needs 3 #14 Gauge conductors recommended between control swutcg and 3MR movement. Preferred colors (not mandatory) are white neutral, blue run and red reset if possible. These are colors shown in the wiring documents and helpful if troubleshooting now or 20 years from now. Power to the switch should be 15A circuit, the motor only draws 5 watts.

White is “neutral”. Goes to “W”

Blue is “normal”. Goes to “B”

Red is “reset”. Goes to “R”

Purple and orange are for an optional pilot clock and are unused. Either cap or cut off.

 

Related products